Pixel Controller – Quad Port Ethernet Controller w/Level Shifter – This board works with WLED and xLights, WLED is already flashed on board ready to run. It has 4 outputs so you can control up to 4 separate strings of pixel lights, up to 800 pixels per port. Works with 12v pixels.
Note: The board needs 5V power to run and output a data signal to pixel lights. It does NOT output 5V to power LED lights, only sends a data signal. You will need to properly connect a power source to your pixel strips or strings. In addition to connecting power and ground from this board to control the pixels. DO NOT connect 12V directly to the board as you will damage the board.
Led Pin Assignments:
-
Led 1: Pin 2
-
Led 2: Pin 4
-
Led 3: Pin 12
-
Led 4: Pin 14
Recommended maximum number of pixels per pin:
-
- 40 Frames Per Second: Up to 600 pixels per port = Up to 2400 pixels per controller
- 20 Frames Per Second: Up to 800 pixels per port = Up to 6400 pixels per controller
Other Product: Pixel Show Starter Kit
Reviews
There are no reviews yet.