Pixel Controller – Six Port Ethernet Controller w/Level Shifter

This board works with WLED and xLights. It has 6 outputs so you can control up to 6 separate strings of pixel lights. Works with either 5v or 12v pixels. You can use the controller through the ethernet port or wirelessly. 

Note: The board needs 5V power to run and output a data signal to pixel lights. It does NOT output 5V to power LED lights, only sends a data signal. You will need to properly connect a power source to your pixel strips or strings. In addition to connecting power and ground from this board to control the pixels. DO NOT connect 12V directly to the board as you will damage the board.

Led Pin Assignments:

• Led 1: Pin 2
• Led 2: Pin 4
• Led 3: Pin 12
• Led 4: Pin 14
• Led 5: Pin 15
• Led 6: Pin 17

Recommended maximum number of pixels per pin:

• 40 Frames Per Second: 500 pixels/pin = About 3000 pixels per controller
• 20 Frames Per Second: 800 pixels/pin = About 4800 pixels per controller