1″ PEX Arch Bases – Pair

1″ PEX Arch Bases – Pair:
You are purchasing a pair of arch bases for 1″ Pex Pipe.

These are our Ultimate Arch Bases. These arch bases are sold as a set and come with all of the required nuts and bolts (PVC, PEX, and EMT pipe not included). Each base has a sturdy base that can interlock with other arch bases by using a 1/2″ PVC pipe. This interlocking pipe also doubles as a wide base preventing your arches from falling forwards or backwards, great for areas with strong winds. Each base has provisions for standard tent stakes to be used to stake the base to the ground.

*It is not recommended to bolt these bases down to a solid surface. This could damage your arch base.

Inside each hole for the arch is a small channel that will allow you to route your power cable from inside the arch through the bottom of the arch. To maintain pressure on the pixel strip inside the tube, a small bungee can be connected to the pixel strip and then wrapped around the 1/2″ EMT pipe that is used to set the distance between arch bases.

Recommendations:

• The PEX can be purchased from Lowes, Home Depot, or Menards

• We recommend that you purchase the PEX Pipe for the arches in a 10′ section instead of bulk in a roll

• The EMT and PVC pipe that is used for the arch spacing and legs should be cut or bought in 5′ sections

  • If you use a different length of EMT, the measurements below won’t jive

• We cut our arch pipes to these lengths

  • Outside Pipe (Single, Dual & Triple): 108″

  • Middle Pipe (Dual & Triple): 102″

  • Inner Pipe (Triple): 96″

1″ PEX Arch Bases – Pair.